Hebei Raoyang Hongyuan Machinery Co.Ltd Favorite | Set Home | Mail
 
You are here: Home>> Company News >>Examines the news
Hose crimping machine
Author : Hose crimping machine  Origin : Hose crimping machine  Issue time : 2012-03-13 10:49:56  Click : 4439

Hose crimping machine thread stripping without

1, check line of cutting depth, adjustable diameter values become smaller.

In 2, the wire transmission wheel clearance is too large, the adjustment into the wire transmission wheel clearance.

In 3, stripping the first set is greater than 2mm.

In 4, the line of dirt.

5, retreat knife set too large, to reduce.

Wire stripping without tail

1, Hose crimping machinecheck line of cutting depth, adjustable diameter values become smaller.

In 2, wire transmission wheel clearance is too large, small wire transmission wheel clearance.

In 3, stripping the first set is greater than 2mm.

4, retreat knife set too large, need to be adjusted in small.

Line leather barotrauma

1, adjusting the line wheel and the wire transmission wheel clearance.

2, contact with the factory, replacing the transmission wheel.

Wire cut bad

1, big diameter numerical, until the appropriate degree (the blade just cut through the line of skin but not hurt wire core is the best position ).

2, if the line of skin is very thin, transferred to the wire diameter after finding no peeling, can properly reduce the knife back value.

Length, actual length greater than or equal to a set length

In 1, the wire transmission wheel clearance is too large, and sometimes stripping without thread, thread stripping on the line is greater than a predetermined length, regulating" into line clearance adjusting wheel", to increase the pressure.

2, inlet tube with stolen goods, please check and appropriate cleaning.

3, Hose crimping machine the adjustment into the wire transmission wheel pressure.

Length, actual length is less than or equal to the preset length

In 1, the wire itself irregular.

In 2, rolling wheel has stolen goods, need to be cleaned. The wire surface wax, lead to import line transmission wheel skid.

3, out of line, program is set to" 00", the empty run, stop, check" into, round round" rotation is flexible or card hysteresis phenomenon.

4, pay-off have card hysteresis phenomenon, causes the input line skid phenomenon.

Part of core line too long

In 1, wire diameter is too small, knife cut wire, strip with a, the need of increasing diameter value 1-2.

2, retreat knife set too small, should be appropriately increased recede cutter parameters.

Sometimes the wires together without cutting off

In 1, the knife edge parts activities plus oil, try again (usually every 8 hours to run gas once).

In 2, the speed is slow, try again.

3, check the wire specifications in this model models allow range.

In 4, the blade is blunt.

Incision inclined tangent

In 1, wire itself is too curved, must straighten.

In 2, wire mouth without facing edge center.

Hose crimping machine 

Previous : fire extinguisher production or maintainence machine
Next : Hose crimping machine principle
 
Products
·Hydraulic Hose
·Hose Crimping Machine
·Hose Swaging Machine
·CNC Hose Crimping Machine
·High Pressure Hose Crimping Machine
·Multifunction Hose Crimping Machine
·Manual Hose Crimping Machine
·Nut Crimping Machine
·Hose Skiving Machine
·Hose Cutting Machine
·Hose Bursting Test Machine

Skype: hjyalice  E_mail:hyalice@hyjx-china.com  Contact Person: Ms Alice Hou
Copyright © Raoyang Hongyuan Machinery CO.,LTD.   Address:Industrial Zone, Raoyang County, Hengshui City, Hebei, China
Hose Crimping Machine, Hose Swaging Machine, Hydraulic Hose